Predator Ridge Metallic Burgundy Phantom Club Car Precedent *PART 2*

We lied! We’re sorry, but we’re hoping it will be okay! 🙂 Last week, we had mentioned that this cart would sit for a little while until spring; however, there were a few more touches we wanted to finish before the Christmas break.


Christmas came early for this cart, a special delivery from Club Car Clause…when we opened the box it was a brand new rear underbody!


Now doesn’t that look great!


Did you know that SC Carts uses Solidworks 3D modeling software to design and create our custom parts. Even a simple part like this gets it’s very own Solidworks drawing and blueprint file!


Now that we designed the part, it’s time to create the part. We start off with a sheet of aluminum.


Next, using our Solidworks blueprint, we cut the pieces to size, drilled the holes and rounded the corners.


Then it was time to fit them to the cart.


And voila! That very simple part has a very important job, it relocates the bumper out further forward to allow for the custom Phantom body to fit properly!

Ok we are now done for sure on this cart until the new year. It has it’s very own parking spot in the shop and will sit safely over the holiday season. We will still be doing some behind the scenes work on this cart, you won’t recognize it next time so be sure to watch for it!

If you haven’t seen part 1, you can see it here.